Use of our heating aids

• 

  Use of our regulator

  Our standard heating aids are controlled by a 3-step regulator, where each step has a unique combination of light and audio signals.

  The regulator is operated by a single button that, when pressed, sets the regulator to it's next step.

• 

  Low

  Green light + 1 short beep indicates that the regulator is set for low temperature.

• 

  Medium

  Yellow light + 2 short beeps indicates that the regulator is set for medium temperature.

• 

  High

  Red light + 3 short beeps indicates that the regulator is set for high temperature.

• 

  Off

  No light + 1 long beep indicates that the regulator is turned off and that no heat is being generated.

• 

  Error

  Blinking green, yellow and red lights + no beeps indicates that an error has occured somewhere in the heating aid.

  If this happens, the heating aid should be sent to us for error analysis and reparation.

• 

  Use of our charger

  Our new standard charger has 2 outputs that each can charge a 3.6V or 7.2V battery simultaneously.

  The charger is fully automatic and starts charging as soon as a compatible battery is connected to it.

• 

  Ready/Charging complete

  Green light indicates that the charger is ready for use or that a connected battery is fully charged.

• 

  Charging in progress

  Red light indicates that a battery is currently being charged.

  When the battery is fully charged, the light will switch to green.

• 

  Error

  Blinking lights indicates that an error has occured somewhere in the charger.

  If this happens, the charger should be sent to us for error analysis and reparation.

Heating aid instructions

Våra standardvärmehjälpmedel levereras vanligtvis i paketlösningar bestående av följande:

• A pair of heating aids.

• A combination of batteries.

• A charger.

• A user manual.

• Two washing pluggs.

• *A pair of battery bands.

(*for insoles, socks or other products without embedded battery pockets)

Using of your heating aids

• Remove the protective plugg covers batteries.

• Open the battery pockets and insert the batteries so the battery cables come out of the pockets on the same side as the regulators, then close the battery pockets.

• Remove the washing pluggs from the regulators and store them in a safe place for future use.

• Connect the batteries to the regulators.

• Start the heating aids by pressing the button on the regulator, and select the setting you want.

Storing your heating aids

When the heating aids are not being used we highly recommend that you turn them off, remove the batteries from them and charge them so you can have maximum time of use the next time you need your heating aids.

Keep the batteries in room temperature when not in use.

Charging your batteries

• Connect the charger to a power source.

• Connect a battery to one of the charger's ports.

• The battery is fully charged when the colour switches to green.

(NOTE! Please only use chargers from minitech to charge our batteries.)

If you have extra batteries you can charge one set while using the other for continuous use of your heating aids.

Cleaning your heating aids

• Disconnect the batteries from the regulator ports.

• Remove the batteries from the battery pockets.

• Putt the washing pluggs back in the regulator ports.

• Wash the heating aids by hand.

• Let them air dry. (Do not use a clothes dryer).